7 Essential Tips For Installing Paver Patios

7 Essential Tips For Installing Paver Patios

Patios are a great way to add a bit of flair to an outside space that have both practical and aesthetic usages. Once thought to be the territory of only those well skilled in construction and manual labor, the truth is that anyone is capable of laying a patio if they take the time to plan accordingly.

The following tips could also prove essential when it comes to installing paver patios.

Make a Plan and Define the Space

A good paving plan is always going to be helpful. Take into consideration where you want your path to be and then go about defining the space by drawing or spraying over a perimeter. Play around with your design until you get it how you want it but also think about drainage and that it slopes away from important structures.

Consult Local Utilities Company

The last thing you want when it comes to paving is to start digging up earth and accidentally break a pipe or cause damage to cables that effect your house and surrounding properties. Consult your local utilities company so that you know where these potential hazard points are.

Order Materials with Easy Maintenance

Because patios can be created with a whole plethora of materials, it’s often difficult knowing where to start when it comes to choosing what to pave with. Choosing Grass Pavers, for example, can prove super useful in terms of the ease of installation and maintenance, as well as the time you’ll save by not having to stain or seal over and over again.

The same goes for ordering materials. Calculate how many pavers you’ll need by measuring up the space and adding a small percentage margin either side. Order a little more than your measurements return to be on the safe side.

Determine the Slope

To avoid problems with flooding and water spilling over pavers, it’s important that the pavers you use are positioned above the surface of the ground.

Determine the high points of your patio by placing a stake to mark it out and then do the same to mark the outer boundaries of the design. This will help mark the lowest points.

From there use line levels and strings to mark out the slope in its entirety.

Excavating

The installation area is paramount. You’ll want to get it right by excavating correctly and knowing how deep you’ll need the base of your patio to be. Measure the depth with the string you used to track the slope and go a little deeper than the width of the pavers themselves.

Laying the Base

Laying the base material must be done beyond the boundaries of the pavers themselves. This will help make your patio more stable and ensure that you keep errors to a minimum.

Edge Restraints

Using edge restraints to help form the shape of your patio is another important tip.

Placing these restraints around the edge of your patio and then securing them will help ensure that your patio doesn’t warp over time. From there you can then go about putting down a layer of sand to help hold pavers in place.

Categories: Business

About Author